Esp8266 Serial ESP 01 Wi-Fi Wireless Transceiver Module Iot
Original price was: ₹200.00.₹190.00Current price is: ₹190.00.
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Integrated TR switch, balun, LNA, power amplifier and matching networ
- Integrated PLLs, regulators, DCXO and power management units
- +19.5dBm output power in 802.11b mode
- Power down leakage current of <10uA
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
Description
 Esp8266 Serial ESP 01 Wi-Fi Wireless Transceiver Module Iot
Description
The ESP-01 ESP8266 Serial WIFI Wireless Transceiver Module is a self-contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all Wi-Fi networking functions from another application processor.
Each ESP8266 module comes pre-programmed with an AT command set firmware, meaning, you can simply hook this up to your Arduno device and get about as much WiFi-ability as a WiFi Shield offers.
The ESP8266 module is an extremely cost-effective board with a huge, and ever growing, community. This module has a powerful enough onboard processing and storage capability that allows it to be integrated with the sensors and other application specific devices through its GPIOs with minimal development up-front and minimal loading during runtime. Its high degree of on-chip integration allows for minimal external circuitry, including the front-end module, is designed to occupy minimal PCB area. The ESP8266 supports APSD for VoIP applications and Bluetooth co-existing interfaces, it contains a self-calibrated RF allowing it to work under all operating conditions and requires no external RF parts.
Additional information
| Weight | 200 g |
|---|---|
| Dimensions | 10 × 10 × 10 cm |
ritu raj –
Works as intended
Did exactly what I needed, programmed the esp fine.
mihir –
Work great
These work great and are easy to program with the Arduino IDE
rohan –
Limited firmware storage.
Great little board if you don’t need a lot of pins
manikandan –
Very nice..
Very easy to use with Windows 10 and the Arduino IDE.It needs a reset button. You have to unplug to cycle power after changing the switch from program to uart,
khuma ram –
Does the job
Saves a lot of time trying to program the ESP8266