Vibration Sensor Switch Module Vibration Sensor Alarm Module for Arduino | Tilt Sensor Module – Black
Original price was: ₹78.00.₹69.00Current price is: ₹69.00.
- Onboard LM393 voltage comparator chip and vibration sensing probe
- Support 5V/3.3V voltage input
- Onboard signal output indication, the output valid signal is low level and the indicator light is on, the output signal can be directly connected with the single chip IO
- The sensitivity of signal detection can be adjusted
- With 3mm screw holes for easy fixing and installation;
- Board size: 29.3*13.8mm Interface Description:
- VCC: positive power supply;
- GND: the negative pole of the power supply;
- OUT: module digital output interface (0 and 1) Product information link: Vibration Sensor Module Package Included:1 x Vibration Sensor Module
Description
The Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino come with the basic components for operation. Supplying power and it is good to be used. Attach it to object and it will detect whether the object is tilt. Simple usage as it is the digital output, so you will know the object is tilt or not by reading the output.
It uses SW-460D or SW-520D tilt sensor. The Tilt Sensor is the ball rolling type, NOT Mercury type.
Comes with an M3 mounting hole for ease of attaching it to an object. On board, it provides a tilt switch, high sensitivity and commonly being used for tilt detection. The module comes with power LED and status LED for the visual indicator.
The module will output logic LOW when the module is not tilted until the threshold angle; it will output logic HIGH when it is tilted over the threshold angle. We have tested, the tilt angle is quite big, from 45 degrees to 130 degrees. However, it depends on the angular velocity too. It can be used as a vibration sensor too.
It can be interfaced with any microcontroller with digital input such as 8051, PIC, SK40C, SK28A,SKds40A,
Pin Connection:
-
VCC = 5V
-
GND = 0V.
-
DO = digital output from module
Note: If the DO is not working, you might need to turn the on-board potentiometer to center.
Features :
- Ball Rolling type of tilt sensor.
- This small module is easy to use.
- Afixed bolt hole for easy installation
- Wide voltage LM393 comparator
Additional information
| Weight | 150 g |
|---|---|
| Dimensions | 10 × 10 × 10 cm |
pradeep –
It works properly
rohit –
This works perfect came in on exact time and for what I’m using it for it works awesome
babu –
Working well so far